Refrigerators and freezers
A fridge that runs but will not cool usually starts with the condenser coils. In apartments, those coils hide underneath or behind the toe grille, matted with dust and pet hair that force the compressor to overwork. Next the tech listens for the evaporator fan behind the freezer panel, because a dead fan leaves a freezer cold and the fresh food side warm. If frost has built up on the evaporator coil, the defrost system is next: heater, defrost thermostat and control board, each checked for continuity with a multimeter. Repeated clicking with no compressor hum often means the start relay or overload has failed.
Washers
A washer full of standing water almost always comes down to the drain path. The tech checks the pump filter for socks, coins and hair ties, then tests the drain pump motor itself. If the machine will not start or spin, the lid switch on a top-loader or the door lock assembly on a front-loader is a common culprit. Heavy banging on spin points to suspension trouble: tired shocks, worn springs or a cracked drum spider.
Dryers
An electric dryer with no heat usually has a blown thermal fuse or dead heating element, while a gas dryer with no heat often has a weak igniter or bad valve coils. A drum that will not turn points to a snapped belt, and a squeal or thump points to worn rollers or an idler pulley. Here is the part people skip: a thermal fuse blows for a reason, and that reason is usually a clogged vent. In high-rise buildings with long vent runs, a good tech checks airflow at the exhaust before closing out the job.
Dishwashers
Water pooling in the tub starts with a check of the filter and drain hose, then the drain pump. If the unit hums but never fills, the water inlet valve and its solenoid get tested. Dishes that come out cold and wet usually mean a failed heating element or high-limit thermostat.
Ranges, ovens and cooktops
A gas oven that clicks but will not light usually has a weak hot surface igniter that no longer pulls enough current to open the safety valve. The tech checks that with a clamp meter, and may use a manometer to confirm gas pressure at the regulator. Electric ovens that heat unevenly often have a broken bake or broil element, and ovens that run hot or cold usually have a drifting temperature sensor, checked against the resistance chart on the tech sheet.
Microwaves
When the light and turntable work but the food stays cold, the magnetron, high-voltage diode or capacitor is a likely suspect. A totally dead microwave often has a blown internal fuse triggered by a bad door switch. Never open a microwave yourself: the high-voltage capacitor can hold a lethal charge long after the unit is unplugged, and a trained tech discharges it safely before touching anything.
